Is there a way to configure two Spotfire data functions to write output of type "Table" to the same Spotfire data table?
Article ID: KB0070270
Updated On:
| Products | Versions |
|---|---|
| Spotfire Analyst | All supported versions |
Description
Is there a way to configure two Spotfire data functions to write output of type "Table" to the same Spotfire data table?
Environment
All supported operating systems
Resolution
No, by design, the Spotfire framework for data functions will only allow one data function to write output of type "Table" to a particular data table.
Issue/Introduction
By design, the Spotfire framework for data functions will only allow one data function to write output of type "Table" to a particular data table.
Was this article helpful?
Yes
No
Powered by
