How to resolve "A system exception has occurred. Custom Java Procedures are not enabled in the server configuration." in TIBCO Data Virtualization ?
Article ID: KB0071687
Updated On:
| Products | Versions |
|---|---|
| TIBCO Data Virtualization | 8.3.1 and later, 8.4.1 and later, 8.5.1 and later, 8.6 and later. |
Description
When working with the resource, The below exception message is seen on the TIBCO Data Virtualization:
------------------------------------------------------------------
" A system exception has occurred. Custom Java Procedures are not enabled in the server configuration."
------------------------------------------------------------------
------------------------------------------------------------------
" A system exception has occurred. Custom Java Procedures are not enabled in the server configuration."
------------------------------------------------------------------
Issue/Introduction
This article explains the exception message which might pop up on the studio while working with resource in TIBCO Data Virtualization.
Environment
All supported environment
Resolution
To resolve this enable the "Enable the ability to run Custom Java Procedures" in TIBCO Data Virtualization studio.
Follow the below steps to enable "Enable the ability to run Custom Java Procedures" in TIBCO Data Virtualization Studio:
1. Open the TIBCO Data Virtualization Studio
2. Navigate to Administration > Configuration > Data Sources > Custom Java Procedure Sources > Enable the ability to run Custom Java Procedure
3. Set "Enable the ability to run Custom Java Procedure " to true and click on Apply.
Follow the below steps to enable "Enable the ability to run Custom Java Procedures" in TIBCO Data Virtualization Studio:
1. Open the TIBCO Data Virtualization Studio
2. Navigate to Administration > Configuration > Data Sources > Custom Java Procedure Sources > Enable the ability to run Custom Java Procedure
3. Set "Enable the ability to run Custom Java Procedure " to true and click on Apply.
Feedback
Yes
No
Powered by
