Difference between "Load" and "Update" message in Scheduling & Routing.
Article ID: KB0076905
Updated On:
| Products | Versions |
|---|---|
| Spotfire Web Player | 7.5 and higher |
Description
When the reports get added in Scheduled update, you can see status messages as "Load" or "Update" under Activity tab in Scheduling & Routing.
Refer below screenshot for same:
Refer below screenshot for same:
Issue/Introduction
Difference between "Load" and "Update" message in Scheduling & Routing.
Environment
All Supported OS
Resolution
Load: It is first load of report at start of schedule.
Update: An update of the report while it is still in cache with an active schedule ("reload every N minutes").
Note: If the data source of analysis file is SBDF and that is on shared drive, then every run of schedule update will show LOAD message.
Update: An update of the report while it is still in cache with an active schedule ("reload every N minutes").
Note: If the data source of analysis file is SBDF and that is on shared drive, then every run of schedule update will show LOAD message.
Feedback
Yes
No
Powered by
