Numerical column added to Cross Table vertical axis in TIBCO Spotfire is auto-binned by default
Article ID: KB0077113
Updated On:
| Products | Versions |
|---|---|
| Spotfire Analyst | All Versions |
Description
When adding a numerical column to the cross table vertical axis, you would like to see all the values displayed for this column, but the column gets auto-binned by default.
Resolution
This vertical axis is auto-binned by design so that there are not too many nodes on the vertical axis. This is because having a very large number of nodes in the vertical axis hierarchy can be very expensive and can cause performance issues in large data sets.
To un-bin the column, use one of the following two options:
1. Click twice to switch from auto-binned to not-binned:
or:
2. Un-check the auto-bin box in the column selector dialog: 
To un-bin the column, use one of the following two options:
1. Click twice to switch from auto-binned to not-binned:
or:
2. Un-check the auto-bin box in the column selector dialog:
Issue/Introduction
Numerical columns that are added to the vertical axis of a Cross Table in the TIBCO Spotfire installed client (TIBCO Spotfire Analyst or TIBCO Spotfire Desktop) are auto-binned by default. It is however possible to remove the binning.
Additional Information
Feedback
Yes
No
Powered by
