Products | Versions |
---|---|
TIBCO LogLogic Log Management Intelligence | 5.0 |
After setting the LMI appliance's timezone in System Settings -> Time tab for UTC+/- offset the appliance will need rebooted. After the required reboot the GUI will reflect the same time as the CLI making searches user-friendly. However, if this is performed during Daylight Saving Time (DST) then the time in the GUI will differ from that returned by the date command in the CLI.
5.0HF3 will needed to be installed but the short-term workaround is to use adjust the appliance's timezone again by 1 hour using the table below. And then after installing 5.0 HF3 the timezone must be changed again back to what the appliance originally was using.
See chart below for USA offsets:
Local Time Subtract from UTC:
Atlantic Standard Four hours
Atlantic Daylight Three hours
Eastern Standard Five hours
Eastern Daylight Four hours
Central Standard Six hours
Central Daylight Five hours
Mountain Standard Seven hours
Mountain Daylight Six hours
Pacific Standard Eight hours
Pacific Daylight Seven hours
Alaskan Standard Nine hours
Alaskan Daylight Eight hours
Hawaiian Standard Ten hours
International customers: check your UTC offset on a web site in your area.