After a reboot, TIBCO LogLogic SEM requires F1 or F2 to continue
Article ID: KB0077423
Updated On:
| Products | Versions |
|---|---|
| TIBCO LogLogic Security Event Manager | all versions |
Description
1. Hit F2 to enter System Setup.
2. Go to SATA settings.
3. Ensure all ports not in use (i.e. any ports not describing Model, Drive Type, etc) are set to Off and NOT Auto.
4. Hit Esc and be sure to Save Changes and Exit.
Issue/Introduction
This article provides the resolution to why LogLogic SEM requires F1 or F2 to continue after a reboot.
Feedback
Yes
No
Powered by
