Looping messages when trying to save workspace: "This operation requires the node name [xxx] to be executed, and may take some time. Proceed?"
Article ID: KB0081778
Updated On:
| Products | Versions |
|---|---|
| Spotfire Statistica | 12.5 |
Description
When deploying a workspace to Enterprise, which has nodes that have to run before deployment, and there is an error in one of the nodes early in the sequence, this may prompt to cause a infinite loop as below:
"This operation requires the node name [xxx] to be executed, and may take some time. Proceed?"
- If you click "Yes", it throws the error message related to the node. Clicking on "OK" for the error message causes the other message to appear again.
- If you click "No" instead, it then keeps cycling through several instances of the same message for different nodes. You need kill the session to get out of the cycle.
"This operation requires the node name [xxx] to be executed, and may take some time. Proceed?"
- If you click "Yes", it throws the error message related to the node. Clicking on "OK" for the error message causes the other message to appear again.
- If you click "No" instead, it then keeps cycling through several instances of the same message for different nodes. You need kill the session to get out of the cycle.
Issue/Introduction
Looping messages when trying to save workspace: "This operation requires the node name [xxx] to be executed, and may take some time. Proceed?"
Environment
Windows
Resolution
WORKAROUND:
A better practice is to run the entire workspace before any deployment.
STATUS:
This issue has been fixed in version 12.7 and higher. The latest version of Statistica can be downloaded from here.
A better practice is to run the entire workspace before any deployment.
STATUS:
This issue has been fixed in version 12.7 and higher. The latest version of Statistica can be downloaded from here.
Feedback
Yes
No
Powered by
