How to apply UsernameToken Authentication policy for a SOAPJMS Facade Operation?
Article ID: KB0083953
Updated On:
| Products | Versions |
|---|---|
| TIBCO API Exchange | ALL |
Description
This article provids sample policy/resource files to configure APIX-G to enforce UsernameToken Authentication on a SOAPJMS Facade Operation.
Environment
All Supported Platforms
Resolution
For applying a UsernameToken authentication policy for a SOAPJMS_Facaade the steps are:
- Define the policy PolicyMapping tab under Security in ConfigUI
- Apply the policy to the Facade Operation under PolicyBinding tab:
- Set OperationURI as the SOAPAction set for the FacadeOperation
- As a JMSFacade would not have a URI.
The attached two files are::
- UTAuth_WSSLdapAsp.policy, the policy
(Note this is different from the shipped sample "AuthenticationByUsernameToken.policy").
- WSS_LdapAsp.properties, the LDAP resource.
(different from the usual sample LdapAsp.properties)
- Define the policy PolicyMapping tab under Security in ConfigUI
- Apply the policy to the Facade Operation under PolicyBinding tab:
- Set OperationURI as the SOAPAction set for the FacadeOperation
- As a JMSFacade would not have a URI.
The attached two files are::
- UTAuth_WSSLdapAsp.policy, the policy
(Note this is different from the shipped sample "AuthenticationByUsernameToken.policy").
- WSS_LdapAsp.properties, the LDAP resource.
(different from the usual sample LdapAsp.properties)
Issue/Introduction
This article provids sample policy/resource files to configure APIX-G to enforce UsernameToken Authentication on a SOAPJMS Facade Operation.
Was this article helpful?
Yes
No
Powered by
