Is it advisable to use a Fault Tolerant (FT) URL with the EMS Administration Tool?
Article ID: KB0084612
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
Description:
==========
Using a FT URL with the EMS Administration Tool. (tibemsadmin -server "tcp://server1:7222, tcp://server2:7022").
Environment:
==========
All versions of TIBCO Enterprise Message Service.
Resolution:
=========
No, the tibemsadmin utility is for administrative purposes only so it has the privilege to be able to connected to both active and standby servers. If you are passing a FT URL to tibemsadmin then it will always be connected to the first URL for which the EMS server is running, irrespective of the EMS server status (active or standby).
Issue/Introduction
Is it advisable to use a Fault Tolerant (FT) URL with the EMS Administration Tool?
Was this article helpful?
Yes
No
Powered by
