Deploying process with EAI DB step from TIBCO Business Studio mixes up the order of Stored Procedure parameters.
Article ID: KB0085525
Updated On:
| Products | Versions |
|---|---|
| TIBCO Business Studio iProcess Add-in | - |
| Not Applicable | - |
Description
Description:
Deploying a process from TIBCO Business Studio that contains a Database Service Task can result in the stored procedure parameters being in the wrong order causing the stored procedure to fail when run as a TIBCO iProcess EAIDB step.
Symptoms:
If the following parameters were defined in the order BBBB, AAAAAAA, CC, HHHHHH, EEEE, FFFFFF, DDDDD, GGGGGG, They would appear in the following order in Business Studio Service Task:
Parameter Type Data Field
BBBB IN B
AAAAAAA IN A
CC IN C
DDDDD IN D
HHHHHH OUT H
EEEE OUT E
FFFFFF OUT F
GGGGG OUT G
In the iProcess Modeler the EAIDB step would show the parameters in the following order,
BBBB
AAAAAAA
CC
HHHHHH
EEEE
FFFFFF
DDDDD
GGGGG
AAAAAAA
CC
HHHHHH
EEEE
FFFFFF
DDDDD
GGGGG
Cause:
Business Studio stores the set of stored procedure parameters in two different sets of content internally in the XPDL. One of these is sorted according to the Studio User Interface properties table order and one is not, it remains in the exact order of parameter creation. The iProcess Export is using the unsorted data set when converting to the EAIDB step.
Resolution
Define all stored procedure parameters for the step in the exact order they are required.
Issue/Introduction
Deploying process with EAI DB step from TIBCO Business Studio mixes up the order of Stored Procedure parameters.
Feedback
Yes
No
Powered by
