Description:
Please refer to the following table for the compatibility between Hawk 5.1 and SNMP adapter 4.9.x

               ?? - Works in both cases, when Hawk 4.9.0 and Hawk 5.1.0 is installed in same Tibco Home and also when they are installed in different Tibco Home

               X? – Doesn’t work when Hawk 4.9.0 and Hawk 5.1.0 is installed in same Tibco Home and works when they are installed in different Tibco Home

           Points to Note:

1.      The compatibility with Hawk 5.1 is assuming that adapters are already installed. If the adapters are tried to be installed after installing Hawk 5.1.0 then the installation of adapters would fail due to installer dependency check and not due to actual API level compatibility.

2.      If Hawk 5.1 is installed in the same tibco home as Hawk 4.9.0 then configurations of Hawk 4.9.0 would be overwritten. In this case the adapters would work but you may have to redo the configurations for Hawk. You may take the backup of the config folder for Hawk 4.9.0 to refer to the original configurations.