TIBCO ActiveMatrix BPM Node fails to start. No entries are written to the BPM.log.
Article ID: KB0087139
Updated On:
| Products | Versions |
|---|---|
| TIBCO BPM Enterprise (formerly TIBCO ActiveMatrix BPM) | - |
| Not Applicable | - |
Description
Description:
Trying to start the TIBCO ActiveMatrix BPM Node with the Administrator
or command line with the tibcohost utility, the Node never starts. No new entries are logged in the BPM.log.
Symptoms:
When trying to start an ActiveMatrix BPM Node, the Node never goes into a
Running state. The BPM.log will not show any errors, or recent
updates. The SystemNode.log will show the following information, indicating why the Node will not start.
18 Sep 2013 09:55:07,036 [Job_Executor1] [INFO ]
com.tibco.amf.hpa.tibcohost.runtime.TibcoHostInstance -
TIBCO-AMX-HPA-000201: anonymous: TIBCO ActiveMatrix host devhost
initiating normal start of node BPMNode
18 Sep 2013 09:55:07,037 [Job_Executor1] [INFO ]
com.tibco.amf.hpa.tibcohost.runtime.TibcoHostInstance -
TIBCO-AMX-HPA-000202: anonymous: TIBCO ActiveMatrix host devhost failed
to initiate start of node BPMNode: TIBCO-AMX-HPA-000236: node BPMNode
has been disabled and cannot be started
Cause:
This can be caused by a failed start due to a JVM crash from perhaps an incorrect JVM setting or change.
Resolution
tibcohost setNodeStartMode -nodeName BPMNode -startMode auto
Where:
-nodeName <nodeName> = Desired node name
-startMode <auto|manual|refresh> = Desired start mode, one of "manual", "auto", or "disabled". Consult your documentation for start mode descriptions.
Tibcohost will start the BMPMNode automatically when tibcohost is started / spawned. If you need to start the BPMNode manually (because other nodes are already running from the same Node) then do:
tibcohost startNodes -nodeName BPMNode
Issue/Introduction
Feedback
