RAD debugger does not show SOAP/JMS endpoints.
Article ID: KB0089120
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix Service Grid | - |
| TIBCO ActiveMatrix Service Bus | - |
| Not Applicable | - |
Description
Description:
When debugging a composite in RAD, SOAP/JMS endpoints do not show up in the "Runtime Components" panel.
Symptoms:
When debugging a composite in RAD, SOAP/JMS endpoints do not show up in the "Runtime Components" panel. See the attached file (Filename: symptoms.jpg).
Cause:
This is due to a defect WSBT-262.
When debugging a composite in RAD, SOAP/JMS endpoints do not show up in the "Runtime Components" panel.
Symptoms:
When debugging a composite in RAD, SOAP/JMS endpoints do not show up in the "Runtime Components" panel. See the attached file (Filename: symptoms.jpg).
Cause:
This is due to a defect WSBT-262.
Issue/Introduction
RAD debugger does not show SOAP/JMS endpoints.
Resolution
The defect was fixed in TIBCO ActiveMatrix ("AMX") 3.3.0. Use TIBCO Business Studio from AMX 3.3.0 / BPM 2.2/3.x which addresses the defect.
Additional Information
WSBT-262
Attachment: symptoms.jpg
Attachment: symptoms.jpg
Attachments
Feedback
Yes
No
Powered by
