If you want to load checkpoints manually, what property do you have to set so that the engine does not load themautomatically when it starts back up?

If you want to load checkpoints manually, what property do you have to set so that the engine does not load themautomatically when it starts back up?

If you want to load checkpoints manually, what property do you have to set so that the engine does not load themautomatically when it starts back up?

book

Article ID: KB0089150

calendar_today

Updated On:

Products	Versions
TIBCO IntegrationManager	-
Not Applicable	-

Description

Resolution:
You have to set the following property to FALSE -
Config.Primary.JobPool.LoadCheckpointedJobsOnStartup: false

Issue/Introduction

If you want to load checkpoints manually, what property do you have to set so that the engine does not load themautomatically when it starts back up?

Was this article helpful?

thumb_up Yes

thumb_down No