It seems that the inbound messages rate, as shown by the "show server" command of the tibemsadmin tool, is sometimes much higher than the actual producer message rate. Why?
Article ID: KB0090447
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
TIBCO Enterprise Message Service (EMS) 4.3 and earlier versions account for both bridged and monitor messages generated in the server as part of the inbound message rate. It explains why the inbound rate is sometimes higher than the rate of actual incoming messages.
From EMS 4.4 onward, this behavior is changed so that the inbound message rate only reports messages that originate from connections, not messages generated internally due to bridged destinations or monitor messages.
Issue/Introduction
It seems that the inbound messages rate, as shown by the "show server" command of the tibemsadmin tool, is sometimes much higher than the actual producer message rate. Why?
Feedback
Yes
No
Powered by
