How do I enable the draft watermark in the web server of TIBCO Nimbus?
Article ID: KB0093213
Updated On:
| Products | Versions |
|---|---|
| TIBCO Nimbus | - |
| Not Applicable | - |
Description
Description:
In order to enable the drat watermark in the web server of Nimbus so that it shows on maps which are in draft, you should follow the below steps
Resolution
The following instructions will enable this function on the Web Server:-
1.) Navigate to the Web Server config.ini file located in ...\\TIBCONimbus\Web Server\Config folder.
2.) Open the file and find 'ShowDraftBanner=0'.
3.) To enable the Draft banner on the Web Server, change the 'ShowDraftBanner=0' to 'ShowDraftBanner=1'.
4.) Save and close the config.ini file.
5.) Restart the Web Server by going to the 'start' menu, 'All Programs', TIBCO Nimbus folder, 'Enterprise Server Admin' and select 'Restart Server'.
1.) Navigate to the Web Server config.ini file located in ...\\TIBCONimbus\Web Server\Config folder.
2.) Open the file and find 'ShowDraftBanner=0'.
3.) To enable the Draft banner on the Web Server, change the 'ShowDraftBanner=0' to 'ShowDraftBanner=1'.
4.) Save and close the config.ini file.
5.) Restart the Web Server by going to the 'start' menu, 'All Programs', TIBCO Nimbus folder, 'Enterprise Server Admin' and select 'Restart Server'.
Issue/Introduction
How do I enable the draft watermark in the web server of TIBCO Nimbus?
Feedback
Yes
No
Powered by
