"The existing TIBCO ActiveMatrix BusinessWorks version in this TIBCO_HOME is not supported for upgrade." warning is seen even when trying to upgrade BW 6.3.1, which is supported for the upgrade.
Article ID: KB0093957
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks | - |
| Not Applicable | - |
Description
Description:
We do not support the upgrading of existing TIBCO_HOME with versions prior to BW 6.3.1. If seeing this warning while upgrading from earlier versions then this warning is legal and you should try installing in a new TIBCO_HOME. Upgrade of BW 6.3.1 to BW 6.3.2 is fully supported.
Symptoms:
Following warning message during upgrade.
###############
TIBCO ActiveMatrix BusinessWorks(TM) - Warning
The existing TIBCO ActiveMatrix BusinessWorks(TM) version in this TIBCO_HOME is not supported for upgrade.
Please install TIBCO ActiveMatrix BusinessWorks(TM) 6.3.2 version in a separate TIBCO_HOME.
For upgrade in same TIBCO_HOME, minimum base TIBCO ActiveMatrix BusinessWorks(TM) 6.x version should be 6.3.1
####################
Cause:
The warning while upgrade from BW 6.3.1 to BW 6.3.2 is observed only when:
1. You had earlier version of BW
-AND-
2. You upgraded this BW version to 6.3.1 prior to upgrading to 6.3.2
Resolution
Uninstall BW 6.3.0 from the TIBCO_HOME using Universal Installer before installing BW 6.3.2 on top of BW 6.3.1
Issue/Introduction
"The existing TIBCO ActiveMatrix BusinessWorks version in this TIBCO_HOME is not supported for upgrade." warning is seen even when trying to upgrade BW 6.3.1, which is supported for the upgrade.
Additional Information
Feedback
Yes
No
Powered by
