Where are TIBCO BusinessWorks process parameters Bus.Default.Service, Bus.Default.Network and Bus.Default.Daemon from when an application is deployed in Fault Tolerant (FT) mode?
Article ID: KB0092312
Updated On:
| Products | Versions |
|---|---|
| TIBCO Administrator | - |
| Not Applicable | - |
Description
Resolution:
For administration domains using TIBCO Rendezvous (RV) transport, they are picked up from the notifier.rv.service, notifier.rv.network, notifier.rv.daemon in the file $TIBCO_TRA_DOMAIN_HOME/domain/domainname/AdministrationDomain.properties on the machines where the process is deployed to.
For administration domains using the TIBCO Enterprise Message Service (EMS) transport, the following default parameters will be used:
There is an enhancement request (BW-14145) created for configuring the FT transport.Bus.Default.Daemon=tcp\:7500Bus.Default.Network=Bus.Default.Service=7500
Issue/Introduction
Where are TIBCO BusinessWorks process parameters Bus.Default.Service, Bus.Default.Network and Bus.Default.Daemon from when an application is deployed in Fault Tolerant (FT) mode?
Was this article helpful?
Yes
No
Powered by
