Changes in Spotfire version 10.3: How to execute commands from the command line in TIBCO Spotfire Server 10.3 and higher
Article ID: KB0078248
Updated On:
| Products | Versions |
|---|---|
| Spotfire Server | 10.3 and higher |
Description
In TIBCO Spotfire Server 10.2 and previous versions, config.bat (config.sh on Linux) - used for executing server commands - was located in <server installation dir>/tomcat/bin.
From version 10.3, this location has changed. To execute commands from the command line, you need to make sure to:
From version 10.3, this location has changed. To execute commands from the command line, you need to make sure to:
- navigate to the new location when opening a command prompt.
- update all scripts (from earlier versions) containing execution of server commands to use the new path to config.bat (or config.sh)
Issue/Introduction
The location of config.bat (config.sh on Linux), used to execute server commands in TIBCO Spotfire Server, has changed. The config.bat is now found in /tomcat/spotfire-bin.
Resolution
From TIBCO Spotfire Server 10.3, config.bat (config.sh on Linux) is located in <server installation dir>/tomcat/spotfire-bin
Additional Information
Doc: Executing commands on the command line
Feedback
Yes
No
Powered by
