Changing A Target Connection When Source And Target Connections Are The Same

Changing A Target Connection When Source And Target Connections Are The Same

book

Article ID: KB0078594

calendar_today

Updated On:

Products Versions
TIBCO Scribe Insight 7.9.1

Description

The option to change the target connection using the Change option in Configure Steps is not enabled when the source and target connections are the same in a DTS.

Each TIBCO Scribe® Insight DTS has a source datastore Connection and one or more target datastore Connections.  Depending on the configuration of your DTS, you may have a target Connection that is the same as your source Connection.  If you need to change a target Connection that is the same as your source Connection, you cannot use the Change option in the Configure Steps dialog.  The Change option is not enabled as shown in the following image:

kA232000000PDtrCAG_en_US_1_0

Issue/Introduction

The option to change the target connection using the Change option in Configure Steps is not enabled when the source and target connections are the same in a DTS.

Resolution

  1. Create a new Connection that is the same as the current source Connection, but with a different Connection name.
  2. On the Work Bench, click Configure Source. The Keep Existing Links warning displays.
  3. Select Keep existing links and click OK.
kA232000000PDtrCAG_en_US_1_1
  1. On the Configure Source dialog, change the source Connection to the new source Connection you just created. All of the data and lookup links are fine since the source fields are the same.
kA232000000PDtrCAG_en_US_1_2
 
  1. When the warning dialog displays, click Yes to use existing objects.
kA232000000PDtrCAG_en_US_1_3
  1. Click OK to return to the Workbench.
  2. On the Target side, click Configure Steps.
  3. Select the Data Objects tab. The Change option is now available and you can change the target Connection.
Powered by Wolken Software