REST data source ignores execution timeout setting
Article ID: KB0080812
Updated On:
| Products | Versions |
|---|---|
| TIBCO Data Virtualization | v 7.0.0 and higher |
Description
The timeout needs to be set at the operation level, as below:
(1) Introspect the data source (click on Add/Remove Resources).
(2) Select the operation (e.g. getData).
After you select the operation, a configuration setting named Operation Execution Timeout will be displayed.
(3) Enter a value for Operation Execution Timeout.
To test, go ahead and execute the operation. The operation should time out based on the value that you entered.
Example
(1) Introspect the data source (click on Add/Remove Resources).
(2) Select the operation (e.g. getData).
After you select the operation, a configuration setting named Operation Execution Timeout will be displayed.
(3) Enter a value for Operation Execution Timeout.
To test, go ahead and execute the operation. The operation should time out based on the value that you entered.
Example
Issue/Introduction
The REST data source has an 'Execution timeout' setting on the Advanced panel. TDV is not using the setting.
Feedback
Yes
No
Powered by
