What is the parameter -name for the ime/imse command.
Article ID: KB0087851
Updated On:
| Products | Versions |
|---|---|
| TIBCO IntegrationManager | - |
| Not Applicable | - |
Description
Resolution:
The ime command supports a parameter "-name".
It is used to assign an engine a name explicitly which overrides the default hostname as the engine name.
The user should assign the engines with unique names when they are using transports like RVCM that have sessions that must be uniquely named within a network.
The engine name is prepended to the RVCM session name to make them unique. This is important if the user plans to run multiple engines for load balancing and they share the same processes that uses named transport sessions.
The ime command supports a parameter "-name".
It is used to assign an engine a name explicitly which overrides the default hostname as the engine name.
The user should assign the engines with unique names when they are using transports like RVCM that have sessions that must be uniquely named within a network.
The engine name is prepended to the RVCM session name to make them unique. This is important if the user plans to run multiple engines for load balancing and they share the same processes that uses named transport sessions.
Issue/Introduction
What is the parameter -name for the ime/imse command.
Feedback
Yes
No
Powered by
