Is it not possible to specify the daemon parameter in IM. In the Channel Edit dialog there is no field for entering this information. The Network and Service parameter's are shown. Is this not supported in IM or am I missing something?

Is it not possible to specify the daemon parameter in IM. In the Channel Edit dialog there is no field for entering this information. The Network and Service parameter's are shown. Is this not supported in IM or am I missing something?

book

Article ID: KB0088439

calendar_today

Updated On:

Products Versions
TIBCO IntegrationManager -
Not Applicable -

Description

Resolution:
It's not specified in the channel. When you attempt to use the channel (in a signal out task for example) there will be a "shared parameters" option. You an specify the daemon parameter there.

Issue/Introduction

Is it not possible to specify the daemon parameter in IM. In the Channel Edit dialog there is no field for entering this information. The Network and Service parameter's are shown. Is this not supported in IM or am I missing something?
Powered by Wolken Software