Is it true that you cannot use Sync Bar in an In-line process?Also, if I use Sync Bar, are those processes after that multi-thread?If I have 3 branchs out of first Sync Bar, can I have more than 3 emerging at second Sync Bar?
Article ID: KB0087873
Updated On:
| Products | Versions |
|---|---|
| TIBCO IntegrationManager | - |
| Not Applicable | - |
Description
Resolution:
-You can use Sync Bar in an In-line process
-The processes after the Sync bar is not multi-threaded.
-If you have 3 branches out of the first Sync bar, you must have 3 merging at the second Sync bar.
-You can use Sync Bar in an In-line process
-The processes after the Sync bar is not multi-threaded.
-If you have 3 branches out of the first Sync bar, you must have 3 merging at the second Sync bar.
Issue/Introduction
Is it true that you cannot use Sync Bar in an In-line process?Also, if I use Sync Bar, are those processes after that multi-thread?If I have 3 branchs out of first Sync Bar, can I have more than 3 emerging at second Sync Bar?
Feedback
Yes
No
Powered by
