How do I set the "acceptTime" parameter for Distributed Queues in Rendezvous 6.x? This parameter existed for RV 5.x.
Article ID: KB0088303
Updated On:
| Products | Versions |
|---|---|
| TIBCO Rendezvous | - |
| Not Applicable | - |
Description
Resolution:
The "acceptTime" parameter cannot be set in RV 6.x. It was removed from visibility to simplify RV for end users. The "acceptTime" parameter is set to 3 seconds and cannot be changed.
Note that this should not cause problems due to the multithreaded nature of RV 6.x. If 3 seconds is an insufficient "acceptTime", there may be a problem with the network or the application.
The "acceptTime" parameter cannot be set in RV 6.x. It was removed from visibility to simplify RV for end users. The "acceptTime" parameter is set to 3 seconds and cannot be changed.
Note that this should not cause problems due to the multithreaded nature of RV 6.x. If 3 seconds is an insufficient "acceptTime", there may be a problem with the network or the application.
Issue/Introduction
How do I set the "acceptTime" parameter for Distributed Queues in Rendezvous 6.x? This parameter existed for RV 5.x.
Feedback
Yes
No
Powered by
