When the TIBCO Adapter for Files v4.1.0-02 is installed, and only "Design-Time Components" is selected, the corresponding DTA Windows service fails to start, because it does not create the required log file.
Article ID: KB0088992
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks Plug-in for Files for Unix and Windows | - |
| Not Applicable | - |
Description
Resolution:
The Installer does not create one of the required directories when you choose to install only the ‘Design-Time Components’, therefore you must manually add the ‘logs’ directory (e.g. C:\TIBCO\Adapter\adfiles\4.1\logs, the DTA will then start without any problems. Further, if both the "Run-Time" and "Design-Time" components are installed the "logs" directory does exist and everything is fine.
The Installer does not create one of the required directories when you choose to install only the ‘Design-Time Components’, therefore you must manually add the ‘logs’ directory (e.g. C:\TIBCO\Adapter\adfiles\4.1\logs, the DTA will then start without any problems. Further, if both the "Run-Time" and "Design-Time" components are installed the "logs" directory does exist and everything is fine.
Issue/Introduction
When the TIBCO Adapter for Files v4.1.0-02 is installed, and only "Design-Time Components" is selected, the corresponding DTA Windows service fails to start, because it does not create the required log file.
Feedback
Yes
No
Powered by
