Setting the SMTP host (GridServer 4.0)
Article ID: KB0087535
Updated On:
| Products | Versions |
|---|---|
| TIBCO DataSynapse GridServer | - |
| Not Applicable | - |
Description
Resolution:
The GridServer Administration Tool can be configured to send notifications via email, via the Event Subscription page. To send the email, there must be a SMTP host configured for the Manager. This is typically configured during Manager installation, but you can later add or change the value.
To set the SMTP host:
1. Click the Manager tab.
2. Click Manager Configuration.
3. Click Admin.
4. In the Mail heading, in SMTP Host, enter the name of your SMTP server. For many organizations, this is simply mail.
5. In Contact Address, enter the email address of an administrative contact. A notification will be sent to this address when new users are added to the Administration Tool.
6. Click Save.
The GridServer Administration Tool can be configured to send notifications via email, via the Event Subscription page. To send the email, there must be a SMTP host configured for the Manager. This is typically configured during Manager installation, but you can later add or change the value.
To set the SMTP host:
1. Click the Manager tab.
2. Click Manager Configuration.
3. Click Admin.
4. In the Mail heading, in SMTP Host, enter the name of your SMTP server. For many organizations, this is simply mail.
5. In Contact Address, enter the email address of an administrative contact. A notification will be sent to this address when new users are added to the Administration Tool.
6. Click Save.
Issue/Introduction
Setting the SMTP host (GridServer 4.0)
Feedback
Yes
No
Powered by
