Changing the HTTP port on a GridServer installation on WebLogic
Article ID: KB0086665
Updated On:
| Products | Versions |
|---|---|
| TIBCO DataSynapse GridServer | - |
| Not Applicable | - |
Description
Resolution:
After changing the HTTP port of a WebLogic installation, you will need to change the value in the GridServer configuration as well so that the Manager reports the correct port. There is currently no way to do this via the GridServer Administration Tool, so the following edit must be made:
In the following files, change the noted values to reflect the new Manager port:
In livecluster/WEB-INF/config/installation.properties, change:
* DSBaseUrl
* DSWebappUrl
* DSPrimaryDirectorHttpPort
In livecluster/WEB-INF/config/driver.properties, change:
* DSWebserverPort
* DSWebserverBaseUrl
After changing the HTTP port of a WebLogic installation, you will need to change the value in the GridServer configuration as well so that the Manager reports the correct port. There is currently no way to do this via the GridServer Administration Tool, so the following edit must be made:
In the following files, change the noted values to reflect the new Manager port:
In livecluster/WEB-INF/config/installation.properties, change:
* DSBaseUrl
* DSWebappUrl
* DSPrimaryDirectorHttpPort
In livecluster/WEB-INF/config/driver.properties, change:
* DSWebserverPort
* DSWebserverBaseUrl
Issue/Introduction
Changing the HTTP port on a GridServer installation on WebLogic
Feedback
Yes
No
Powered by
