I am trying to use JMS as messaging mechanism in SmartMapper "Adapter-based SmartMaper Service" but when I try to do "Test Connection" under "Transport" I get below Error "Connection Failed. Protocol not supported".
Article ID: KB0086666
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks Plug-in for SmartMapper | - |
| Not Applicable | - |
Description
Resolution:
You are getting this Error because you have not selected the "JNDI Lookups" checkbox , once you do that you should not get this Error .
You need to do this same for "DefaultJmsQueueSession" under "Advanced" of "SmartMapperAdapterConfiguration" Configuration.
You are getting this Error because you have not selected the "JNDI Lookups" checkbox , once you do that you should not get this Error .
You need to do this same for "DefaultJmsQueueSession" under "Advanced" of "SmartMapperAdapterConfiguration" Configuration.
Issue/Introduction
I am trying to use JMS as messaging mechanism in SmartMapper "Adapter-based SmartMaper Service" but when I try to do "Test Connection" under "Transport" I get below Error
"Connection Failed. Protocol not supported".
Feedback
Yes
No
Powered by
