The Siebel Adapter run-time and Design-time connection tabs in Designer does not allow the "Siebel Server" parameter to be left blank
Article ID: KB0090193
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks Plug-in for Siebel | - |
| Not Applicable | - |
Description
Description:
Symptoms
=========
While connecting to Siebel Resonate Server, the Server parameter should be left blank. Because of the check in Designer, the run-time and design Adapters are not able to connect to Siebel Server with Resonate configuration
Impact
======
Loss of Functioanlity
Workaround
==========
- create a new global variable with empty (blank) value.
- use this global variable in the "Siebel Server" parameter in run-time/design-time connection tab
- do "not" substitute any value for this global variable while connecting to Design-time Adapter or starting the Adapter
Resolution
==========
This is fixed in 5.2.0 version of the Siebel Adapter
Symptoms:
Cause:
Issue/Introduction
The Siebel Adapter run-time and Design-time connection tabs in Designer does not allow the "Siebel Server" parameter to be left blank
Feedback
Yes
No
Powered by
