Can BW2.0,BW5.2, and BW5.3 coexist on the same machine?
Article ID: KB0091054
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks | - |
| Not Applicable | - |
Description
Resolution:
We didn't test this combination; however, TIBCO products use a three-digit release number that makes it possible to specify major, minor, and patch release. For example, release 2.1.3 means major version 2, minor version 1, and patch 3.
If you are installing a major or minor release, the installer will create a new directory in the directory of the old installation that is named after the two-digit release number. For example, if your prior tra version was installed in c:\tibco\BW\5.2, and you install version 5.3, the product will be installed in c:\tibco\tBW\5.3. This allows both the 5.3 and 5.2 releases to coexist on the same machine.
In your case if you have the combination of 2.x and 5.2 on the same mahcine and successfully executing these two versions then based on above 5.3 should be able to coexist with these two products.
We didn't test this combination; however, TIBCO products use a three-digit release number that makes it possible to specify major, minor, and patch release. For example, release 2.1.3 means major version 2, minor version 1, and patch 3.
If you are installing a major or minor release, the installer will create a new directory in the directory of the old installation that is named after the two-digit release number. For example, if your prior tra version was installed in c:\tibco\BW\5.2, and you install version 5.3, the product will be installed in c:\tibco\tBW\5.3. This allows both the 5.3 and 5.2 releases to coexist on the same machine.
In your case if you have the combination of 2.x and 5.2 on the same mahcine and successfully executing these two versions then based on above 5.3 should be able to coexist with these two products.
Issue/Introduction
Can BW2.0,BW5.2, and BW5.3 coexist on the same machine?
Feedback
Yes
No
Powered by
