Description:
Current wording in the Installation Guide, Chapter 1 Introduction,
for the iProcess BusinessWorks Client Plug-in system requirements:-

If you have installed the TIBCO iProcess Client in a directory that
contains spaces, you must un-install it and re-install it in a
directory that does not contain spaces. This is because the
TIBCO iProcess BusinessWorks Client Plug-in will not install in a
directory that contains spaces.

Will be replaced with the revised wording:-

If you have installed the TIBCO iProcess Client in a directory that
contains spaces, hyphens or other non-alphanumeric characters
(with the exception of underscore), you must un-install it and
re-install it in a directory that does not contain spaces.
This is because the TIBCO iProcess BusinessWorks Client
Plug-in will not install in a directory that contains non-supported
characters.
Symptoms:

Cause:

[This KA was unapproved and obsolete when migrated.] TIBCO iProcess BusinessWorks Connector Installation Guide update regarding the permitted characters for target installation locations.