I cannot setup XML Canon to authenticate against TIBCO administrator credentials. When I perform the setup and press “Verify”, I receive the error message “Couldn't verify connection. Check connection parameters.”
Article ID: KB0090474
Updated On:
| Products | Versions |
|---|---|
| TIBCO XML Canon | - |
| Not Applicable | - |
Description
Resolution:
This is a known issue in XML Canon 3.0 and 3.1 (see CR #1-6SS4TC). Use the following workaround to resolve it:
1. Obtain the file 'tibcorealm.war' from your TIBCO Admin installation
2. Place the 'tibcorealm.war' file in your /TIBCO/administrator/domain/YourTibcoAdminDomainName/tomcat/webapps
3. Login to XML Canon using an Admin account
4. Browse “Configure” > “Policies” > “Authentication”
5. Select “TIBCO Administrator Authentication” and press “Update”
6. Complete the setup and press “Verify”
7. Exit the server and then re-login using TIBCO Admin username and password
This is a known issue in XML Canon 3.0 and 3.1 (see CR #1-6SS4TC). Use the following workaround to resolve it:
1. Obtain the file 'tibcorealm.war' from your TIBCO Admin installation
2. Place the 'tibcorealm.war' file in your /TIBCO/administrator/domain/YourTibcoAdminDomainName/tomcat/webapps
3. Login to XML Canon using an Admin account
4. Browse “Configure” > “Policies” > “Authentication”
5. Select “TIBCO Administrator Authentication” and press “Update”
6. Complete the setup and press “Verify”
7. Exit the server and then re-login using TIBCO Admin username and password
Issue/Introduction
I cannot setup XML Canon to authenticate against TIBCO administrator credentials. When I perform the setup and press “Verify”, I receive the error message “Couldn't verify connection. Check connection parameters.”
Feedback
Yes
No
Powered by
