Why does EMS 4.4 Server complain about the SmartSockets (tibss) transport under Windows when attempting to connect to a SmartSockets 6.8 RTserver?
Article ID: KB0090802
Updated On:
| Products | Versions |
|---|---|
| TIBCO SmartSockets | - |
| Not Applicable | - |
Description
Resolution:
Problem:
When specifying the SmartSockets transport in the transports.conf file the EMS server generates the following error:
file=transports.conf, line=X: transport is not supported on this platform.
ERROR: Configuration error:
file=transports.conf, line=X: error in the transport description, unable to proceed.
Solution:
There are two EMS 4.4 distributions for Windows. They are:
TIB_ems-simple_4.4.0_win_x86.exe
TIB_ems-simple_4.4.0_win32_x86_vc8.exe
Because SmartSockets 6.8.0 on Windows is built using VC8 you must use the tibemsd in the TIB_ems-simple_4.4.0_win32_x86_vc8.exe distribution if you are going to bridge to a SmartSockets 6.8 RTserver.
Problem:
When specifying the SmartSockets transport in the transports.conf file the EMS server generates the following error:
file=transports.conf, line=X: transport is not supported on this platform.
ERROR: Configuration error:
file=transports.conf, line=X: error in the transport description, unable to proceed.
Solution:
There are two EMS 4.4 distributions for Windows. They are:
TIB_ems-simple_4.4.0_win_x86.exe
TIB_ems-simple_4.4.0_win32_x86_vc8.exe
Because SmartSockets 6.8.0 on Windows is built using VC8 you must use the tibemsd in the TIB_ems-simple_4.4.0_win32_x86_vc8.exe distribution if you are going to bridge to a SmartSockets 6.8 RTserver.
Issue/Introduction
Why does EMS 4.4 Server complain about the SmartSockets (tibss) transport under Windows when attempting to connect to a SmartSockets 6.8 RTserver?
Feedback
Yes
No
Powered by
