How to achieve EMS FT and LB in BW?
Article ID: KB0087333
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks | - |
| Not Applicable | - |
Description
Resolution:
To achieve both FT and load balancing, here are some tips:
For example If you wish to have two engines in load balancing (JMS queue), create two FT groups (create an EAR file with two process archives),
have two engines in each FT group during depolyment. Now you have a total of four engines, out of which only two will be active at any given time.
These two active engines will be running in load balance mode.
In your EMS Connection you only need to specify "tcp://localhost:7222,tcp://localhost:7444".
KEYWORDS: FT, LB, EMS, QUEUE
To achieve both FT and load balancing, here are some tips:
For example If you wish to have two engines in load balancing (JMS queue), create two FT groups (create an EAR file with two process archives),
have two engines in each FT group during depolyment. Now you have a total of four engines, out of which only two will be active at any given time.
These two active engines will be running in load balance mode.
In your EMS Connection you only need to specify "tcp://localhost:7222,tcp://localhost:7444".
KEYWORDS: FT, LB, EMS, QUEUE
Issue/Introduction
How to achieve EMS FT and LB in BW?
Feedback
Yes
No
Powered by
