Why BusinessWorks container does not show up in AMX Administrator after installing BW SE into existing Matrix framework?.
Article ID: KB0090696
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks Service Engine | - |
| Not Applicable | - |
Description
Resolution:
Installing Product on the Existing ActiveMatrix Environment:-
If you are installing the product on an already existing ActiveMatrix environment, there is a high possibility that nodes have been created and are running. Once the product is installed, the BusinessWorks container shows up in the list of containers that can be enabled for a node in ActiveMatrix Administrator’s Configure an Environment perspective.
You must stop the node before you can enable the BusinessWorks container for the node. Following steps describe the procedure:
1. Select the node from the list of nodes. If the node is running, click Stop to stop the node.
2. Click Service Units tab to see a list of service units available for the node. The BusinessWorks container is listed.
3. Click Edit and select Enable to enable the BusinessWorks container for the node.
4. Click Save and Start the node
P.S - this is also documented in page 16 of the BW SE user guide.
Installing Product on the Existing ActiveMatrix Environment:-
If you are installing the product on an already existing ActiveMatrix environment, there is a high possibility that nodes have been created and are running. Once the product is installed, the BusinessWorks container shows up in the list of containers that can be enabled for a node in ActiveMatrix Administrator’s Configure an Environment perspective.
You must stop the node before you can enable the BusinessWorks container for the node. Following steps describe the procedure:
1. Select the node from the list of nodes. If the node is running, click Stop to stop the node.
2. Click Service Units tab to see a list of service units available for the node. The BusinessWorks container is listed.
3. Click Edit and select Enable to enable the BusinessWorks container for the node.
4. Click Save and Start the node
P.S - this is also documented in page 16 of the BW SE user guide.
Issue/Introduction
Why BusinessWorks container does not show up in AMX Administrator after installing BW SE into existing Matrix framework?.
Feedback
Yes
No
Powered by
