What is the cause for Hawk Agent failure with error "TibrvException[error=1,message=Initialization failed]" during initialization?
Article ID: KB0091254
Updated On:
| Products | Versions |
|---|---|
| TIBCO Hawk | - |
| Not Applicable | - |
Description
Resolution:
In most situations, it means the Hawk agent rv port is occupied by other application.
You can:
-use "netstat -a" to check whether the UDP port (7474) is already used or not.
-use "netstat -ao" to check which process (PID) is using the UDP port (7474).
-kill the process or change rvd port configure, then restart Hawk agent
In most situations, it means the Hawk agent rv port is occupied by other application.
You can:
-use "netstat -a" to check whether the UDP port (7474) is already used or not.
-use "netstat -ao" to check which process (PID) is using the UDP port (7474).
-kill the process or change rvd port configure, then restart Hawk agent
Issue/Introduction
What is the cause for Hawk Agent failure with error "TibrvException[error=1,message=Initialization failed]" during initialization?
Feedback
Yes
No
Powered by
