Is it possible to enable flowControl for bridges?
Article ID: KB0091507
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
Yes, we can do that.
Flow control can be specified on destinations that are bridged to other destinations. If you wish the flow of messages sent by way
of the bridge to slow down when receivers on the bridged-to destination cannot process the messages quickly enough, you must set
the flowControl property on both destinations on either side of the bridge.
The flowControl will take effect only when the source destination is set flowControl (of course, flowcontrol should be enabled from
EMS main configuration file). If the source destination is not flowControl, only target destinations are set flowControl, the flowControl
will not take place.
Yes, we can do that.
Flow control can be specified on destinations that are bridged to other destinations. If you wish the flow of messages sent by way
of the bridge to slow down when receivers on the bridged-to destination cannot process the messages quickly enough, you must set
the flowControl property on both destinations on either side of the bridge.
The flowControl will take effect only when the source destination is set flowControl (of course, flowcontrol should be enabled from
EMS main configuration file). If the source destination is not flowControl, only target destinations are set flowControl, the flowControl
will not take place.
Issue/Introduction
Is it possible to enable flowControl for bridges?
Feedback
Yes
No
Powered by
