Why I could not delete the bridge even if show bridges shows that there is a bridge?
Article ID: KB0091499
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
In order to delete the bridge, you need to use the delete bridge command in Administration Tool as follows:
delete bridge source=<type>:<name> target=<type>:<name>
If target destination does not exist, you will encounter "Bridge not found" error when attempting to
delete a bridge with the tibemsadmin utility. Though show bridge shows the bridge details, need
target to delete it. Otherwise, it will give this error. This is an expected behavior only.
In order to delete the bridge, you need to use the delete bridge command in Administration Tool as follows:
delete bridge source=<type>:<name> target=<type>:<name>
If target destination does not exist, you will encounter "Bridge not found" error when attempting to
delete a bridge with the tibemsadmin utility. Though show bridge shows the bridge details, need
target to delete it. Otherwise, it will give this error. This is an expected behavior only.
Issue/Introduction
Why I could not delete the bridge even if show bridges shows that there is a bridge?
Feedback
Yes
No
Powered by
