Why does the adapter fail after upgrading to TIBCO Adapter(TM) for SWIFT v5.7.0?
Article ID: KB0088259
Updated On:
| Products | Versions |
|---|---|
| TIBCO Adapter for SWIFT | - |
| Not Applicable | - |
Description
Resolution:
Description:
==========
After upgrading to TIBCO Adapter(TM) for SWIFT (SWIFT Adapter) v5.7.0, the FIN messages containing the 'S' block failed.
Environment:
===========
TIBCO Adapter for SWIFT v5.7.0
Symptoms:
=========
The SWIFT Adapter failed while performing any operation on the FIN message, once the SWIFT Adapter has been upgraded to v5.7.0.
Cause:
======
The support for 'S' block has been added from SWIFT Adapter v5.7.0. Validation and Parsing of the 'S' Block is being done only from SWIFT Adapter v5.7.0 onwards. This 'S' block schema was not included in the prior version of the adapter. When the SWIFT Adapter v5.7.0 validates and tries to parse the message for the S block, it fails.
Resolution:
=========
The schema needs to be imported again for each FIN message.
Description:
==========
After upgrading to TIBCO Adapter(TM) for SWIFT (SWIFT Adapter) v5.7.0, the FIN messages containing the 'S' block failed.
Environment:
===========
TIBCO Adapter for SWIFT v5.7.0
Symptoms:
=========
The SWIFT Adapter failed while performing any operation on the FIN message, once the SWIFT Adapter has been upgraded to v5.7.0.
Cause:
======
The support for 'S' block has been added from SWIFT Adapter v5.7.0. Validation and Parsing of the 'S' Block is being done only from SWIFT Adapter v5.7.0 onwards. This 'S' block schema was not included in the prior version of the adapter. When the SWIFT Adapter v5.7.0 validates and tries to parse the message for the S block, it fails.
Resolution:
=========
The schema needs to be imported again for each FIN message.
Issue/Introduction
Why does the adapter fail after upgrading to TIBCO Adapter(TM) for SWIFT v5.7.0?
Feedback
Yes
No
Powered by
