How to refresh the pattern file in memory if the TIBCO Hawk® agent is not restarted?
Article ID: KB0087735
Updated On:
| Products | Versions |
|---|---|
| TIBCO Hawk | - |
| Not Applicable | - |
Description
Resolution:
Description:
============
Normally, if a pattern file is read by a TIBCO Hawk® rule, when the pattern file is updated, the rule is still using the old values of the pattern file. It happens unless the TIBCO Hawk® agent is restarted. But sometimes customer hope to refresh the pattern file in memory but not restarting the TIBCO Hawk® agent.
Environment:
============
o ALL
Resolution:
===========
You can take the following workaround: every time you update the contents of pattern file, you can change the name of pattern file also and reference the new pattern file name in the rulebase. So in this case, the rulebase will read the new pattern file not the old file.
Description:
============
Normally, if a pattern file is read by a TIBCO Hawk® rule, when the pattern file is updated, the rule is still using the old values of the pattern file. It happens unless the TIBCO Hawk® agent is restarted. But sometimes customer hope to refresh the pattern file in memory but not restarting the TIBCO Hawk® agent.
Environment:
============
o ALL
Resolution:
===========
You can take the following workaround: every time you update the contents of pattern file, you can change the name of pattern file also and reference the new pattern file name in the rulebase. So in this case, the rulebase will read the new pattern file not the old file.
Issue/Introduction
How to refresh the pattern file in memory if the TIBCO Hawk® agent is not restarted?
Feedback
Yes
No
Powered by
