Configuring load balancing of TIBCO Business Works (BW) webservices that are running in TIBCO Business Events (BE) container.
Article ID: KB0086378
Updated On:
| Products | Versions |
|---|---|
| TIBCO BusinessEvents Enterprise Edition | - |
| Not Applicable | - |
Description
Resolution:
Description:
============
The BE multi-engine mode/load balancing feature is not applicable to the BW webservices running inside the BE container so it needs to be configured seperately.
For example, if the webservices are using HTTP transport then you can use a hardware load balancer (like BIG-IP) with a virtual IP address to route the actual incoming webservice requests to the individual servers
A virtual IP address is an IP address that is not connected to a specific computer or network interface card (NIC) on a computer. You configure a load balancer to use with this IP address so that the load balancer routes the incoming requests to the actual hosts/IP addresses in a round-robin fashion.
Environment:
============
o TIBCO BusinessEvents 3.0.1
o All OS
Description:
============
The BE multi-engine mode/load balancing feature is not applicable to the BW webservices running inside the BE container so it needs to be configured seperately.
For example, if the webservices are using HTTP transport then you can use a hardware load balancer (like BIG-IP) with a virtual IP address to route the actual incoming webservice requests to the individual servers
A virtual IP address is an IP address that is not connected to a specific computer or network interface card (NIC) on a computer. You configure a load balancer to use with this IP address so that the load balancer routes the incoming requests to the actual hosts/IP addresses in a round-robin fashion.
Environment:
============
o TIBCO BusinessEvents 3.0.1
o All OS
Issue/Introduction
Configuring load balancing of TIBCO Business Works (BW) webservices that are running in TIBCO Business Events (BE) container.
Feedback
Yes
No
Powered by
