ConfigStore Management Interface option not displayed after installation.
Article ID: KB0089135
Updated On:
| Products | Versions |
|---|---|
| TIBCO BusinessConnect | - |
| Not Applicable | - |
Description
Resolution:
Description
==========
After installing the BusinessConnect ConfigStore Management Interface protocol (CMI version 1.0.0) the CMI protocol is not listed in the ‘Activate/Deactivate Protocols’ section under theTIBCO Admininstrator -> Business Connect -> Manage Installation window . The JDBC details, installation name, etc. are all correct. It is showing only the EDI protocol.
Environment
===========
TIBCO BusinessConnect 5.X
BC CMI 1.0.0
Resolution
==========
Stop and start the Admininstrator after CMI is installed. The CMI interface will then appear under the Manage Installation window.
Description
==========
After installing the BusinessConnect ConfigStore Management Interface protocol (CMI version 1.0.0) the CMI protocol is not listed in the ‘Activate/Deactivate Protocols’ section under theTIBCO Admininstrator -> Business Connect -> Manage Installation window . The JDBC details, installation name, etc. are all correct. It is showing only the EDI protocol.
Environment
===========
TIBCO BusinessConnect 5.X
BC CMI 1.0.0
Resolution
==========
Stop and start the Admininstrator after CMI is installed. The CMI interface will then appear under the Manage Installation window.
Issue/Introduction
ConfigStore Management Interface option not displayed after installation.
Feedback
Yes
No
Powered by
