[copy-edit approved][SME approved]How to test the Logfile microagent in a rulebase?
Article ID: KB0088181
Updated On:
| Products | Versions |
|---|---|
| TIBCO Hawk | - |
| Not Applicable | - |
Description
Resolution:
[SME Comments] Recommended Scope: Customer
Description:
===========================
You sometimes encounter a problem when testing the rulebase using the Logfile microagent. You add a line in the log file being monitored but you do not get the expected action.
Environment:
===========================
All
Resolution:
============================
Normally this is caused by using an incorrect method when adding a new line in the log file. A user should not use any text edit tool to edit the log file. The best way is to use the "echo" command to append a test line at the end of the log file, such as the following:
echo <testline> >> <logfile>
[SME Comments] Recommended Scope: Customer
Description:
===========================
You sometimes encounter a problem when testing the rulebase using the Logfile microagent. You add a line in the log file being monitored but you do not get the expected action.
Environment:
===========================
All
Resolution:
============================
Normally this is caused by using an incorrect method when adding a new line in the log file. A user should not use any text edit tool to edit the log file. The best way is to use the "echo" command to append a test line at the end of the log file, such as the following:
echo <testline> >> <logfile>
Issue/Introduction
[copy-edit approved][SME approved]How to test the Logfile microagent in a rulebase?
Feedback
Yes
No
Powered by
