[copy-edit approved][SME Approved] Does TIBCO Hawk support using different username/password to connect different TIBCO Enterprise Message (EMS) servers in fault tolerance pair?
Article ID: KB0088629
Updated On:
| Products | Versions |
|---|---|
| TIBCO Hawk | - |
| Not Applicable | - |
Description
Resolution:
[SME Commets] Recommended Scope: Customer
Description:
================
No, Hawk does support fault tolerance configuration. Hawk only supports the same username/password as follows:
# -ems_transport tcp://emshost:7222,tcp://emshost:7222 user "#!encrypted"
[SME Commets] Recommended Scope: Customer
Description:
================
No, Hawk does support fault tolerance configuration. Hawk only supports the same username/password as follows:
# -ems_transport tcp://emshost:7222,tcp://emshost:7222 user "#!encrypted"
Issue/Introduction
[copy-edit approved][SME Approved] Does TIBCO Hawk support using different username/password to connect different TIBCO Enterprise Message (EMS) servers in fault tolerance pair?
Feedback
Yes
No
Powered by
