How to control the location of the configuration files when using silent installation?
Article ID: KB0085734
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
Description:
= = = = = = =
Defining the location of the configure files when using the silent installer.
Environment:
= = = = = = =
ALL
Resolution:
= = = = = =
The location of configuration files are defined in the silent response file which is used to install the EMS server. In that file, the following property should be defined with the
location of the EMS server’s configuration files:
!-- configDirectory - location of configuraiton files if it does not already exist -->
<entry key="configDirectoryRoot">C:\\progData\\tibco</entry>
Ketwords/Tags:
= = = = = = = = =
Silent installation
Description:
= = = = = = =
Defining the location of the configure files when using the silent installer.
Environment:
= = = = = = =
ALL
Resolution:
= = = = = =
The location of configuration files are defined in the silent response file which is used to install the EMS server. In that file, the following property should be defined with the
location of the EMS server’s configuration files:
!-- configDirectory - location of configuraiton files if it does not already exist -->
<entry key="configDirectoryRoot">C:\\progData\\tibco</entry>
Ketwords/Tags:
= = = = = = = = =
Silent installation
Issue/Introduction
How to control the location of the configuration files when using silent installation?
Feedback
Yes
No
Powered by
