How to know which TIBCO Enterprise Message Service (EMS) server instance is active and which instance is standby using TIBCO Administrator?
Article ID: KB0089904
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
Description:
-----------------
When two EMS servers have been configured in Fault Tolerant (FT) mode and deployed in TIBCO Administrator, both of them are shown in a “running” state.
Environment:
------------------
TIBCO Enterprise Message Service – All versions
TIBCO Administrator – All versions
All OS Platforms
Resolution:
------------------
Though TIBCO Administrator shows both EMS instances as running on the home page, you can click on the link for each server instance which will provide more information about that instance including whether it is active or backup.
Description:
-----------------
When two EMS servers have been configured in Fault Tolerant (FT) mode and deployed in TIBCO Administrator, both of them are shown in a “running” state.
Environment:
------------------
TIBCO Enterprise Message Service – All versions
TIBCO Administrator – All versions
All OS Platforms
Resolution:
------------------
Though TIBCO Administrator shows both EMS instances as running on the home page, you can click on the link for each server instance which will provide more information about that instance including whether it is active or backup.
Issue/Introduction
How to know which TIBCO Enterprise Message Service (EMS) server instance is active and which instance is standby using TIBCO Administrator?
Feedback
Yes
No
Powered by
