How to configure BW to support TLS?
Article ID: KB0094222
Updated On:
| Products | Versions |
|---|---|
| TIBCO ActiveMatrix BusinessWorks | - |
| Not Applicable | - |
Description
Resolution:
Description
===========
Client side fails to call BW service or HTTP Receiver using the HTTPS protocol with TLS enabled. If SSL tracing is enabled, you can see the SSL handshake does not complete normally. Errors may vary.
Environment
==========
All OS
All BW version
Resolution
=========
Using TRA 5.6.0 Hotfix-8 can address this problem. TRA 5.6.0 Hotfix-8 bundles the latest Entrust (7.2 SP1 160686) which supports TLS extensions.
Description
===========
Client side fails to call BW service or HTTP Receiver using the HTTPS protocol with TLS enabled. If SSL tracing is enabled, you can see the SSL handshake does not complete normally. Errors may vary.
Environment
==========
All OS
All BW version
Resolution
=========
Using TRA 5.6.0 Hotfix-8 can address this problem. TRA 5.6.0 Hotfix-8 bundles the latest Entrust (7.2 SP1 160686) which supports TLS extensions.
Issue/Introduction
How to configure BW to support TLS?
Feedback
Yes
No
Powered by
