What state is reported when the EMS server is recovering datastores before it becomes active after a failover event?
Article ID: KB0094517
Updated On:
| Products | Versions |
|---|---|
| TIBCO Enterprise Message Service | - |
| Not Applicable | - |
Description
Resolution:
Environment:
==========
All
Resolution:
==========
During a failover event, when the server is in its recovery mode and before it becomes fully active, you will not be able to connect to the tibemsadmin tool and obtain the state of the server. A server that is in recovery mode is able to "accept" client connection requests but these connections are not completely established until the server becomes fully active.
An already connected tibemsadmin client will be disconnected when the server enters into recovery mode. In the tibemsadmin tool the following message will be reported:
“Disconnected from tcp://<host>:<port>”.
Environment:
==========
All
Resolution:
==========
During a failover event, when the server is in its recovery mode and before it becomes fully active, you will not be able to connect to the tibemsadmin tool and obtain the state of the server. A server that is in recovery mode is able to "accept" client connection requests but these connections are not completely established until the server becomes fully active.
An already connected tibemsadmin client will be disconnected when the server enters into recovery mode. In the tibemsadmin tool the following message will be reported:
“Disconnected from tcp://<host>:<port>”.
Issue/Introduction
What state is reported when the EMS server is recovering datastores before it becomes active after a failover event?
Feedback
Yes
No
Powered by
