Outbound X12 documents are being created without the ISA or GS segments.How can this be fixed?
Article ID: KB0084825
Updated On:
| Products | Versions |
|---|---|
| TIBCO BusinessConnect EDI Protocol Powered by Instream | - |
| Not Applicable | - |
Description
Resolution:
Description:
============
When an X12 document is sent on the outbound , the ISA and GS segments are not being populated .
Environment:
==========
Applies to all the environments.
Symptoms:
=========
If you check the message that is sent on the outbound it is either a 0 kb file or the values are not populated properly.
Cause:
=====
The ISA and GS segments should not be force mapped in a BusinessWorks (BW) project when using a mapper object. These two segments are automatically populated by BC. Only the ST segment should be populated in the BW project.
Resolution:
=========
Remove any mappings of ISA and GS in the BW project . BC will automatically populate these segments during EDI document generation.
Description:
============
When an X12 document is sent on the outbound , the ISA and GS segments are not being populated .
Environment:
==========
Applies to all the environments.
Symptoms:
=========
If you check the message that is sent on the outbound it is either a 0 kb file or the values are not populated properly.
Cause:
=====
The ISA and GS segments should not be force mapped in a BusinessWorks (BW) project when using a mapper object. These two segments are automatically populated by BC. Only the ST segment should be populated in the BW project.
Resolution:
=========
Remove any mappings of ISA and GS in the BW project . BC will automatically populate these segments during EDI document generation.
Issue/Introduction
Outbound X12 documents are being created without the ISA or GS segments.How can this be fixed?
Feedback
Yes
No
Powered by
